12.8.7. Configuring terminal servers

This section describes how to configure terminal servers using the CLI. You configure them at the users terminal-servers level.

To create a terminal server, use the following command:

Admin@UGOS# create users terminal-servers

Provide the following parameters:

Parameter

Description

enabled

Enable/disable a terminal server:

  • on.

  • off.

name

Terminal server name.

description

Terminal server description.

host

Host IP address. To add more than one address, separate them with commas.

To update a terminal server's parameters (listed in the table above), use the following command:

Admin@UGOS# set users terminal-servers <terminal-server-name>

To delete a terminal server, use the following command:

Admin@UGOS# delete users terminal-servers <terminal-server-name>

You can also delete individual hosts. To delete them specify their addresses:

Admin@UGOS# delete users terminal-servers <terminal-server-name> host

To display information about a terminal server, use the following command:

Admin@UGOS# show users terminal-servers <terminal-server-name>